两个基于2,5-二甲氧基对苯二甲酸和咪唑衍生物的超分子钴配位聚合物的结构及光催化反应

本文以咪唑衍生物为配体,通过水热合成法与钴离子制备出两个配位聚合物:{[Co(DTA)(1,4-DIB)(H₂O)]·H₂O}_n(1)和[Co(DTA)(1,3-BMIB)]_n(2)(1,4-DIB=1,4-二(1H-咪唑-1-基)苯; 1,3-BMIB=1,3-二(4-甲基-1H-咪唑-1-基)苯;H₂DTA=2,5-二甲氧基对苯二甲酸)。利用X射线单晶衍射、粉末衍射、热失重、元素分析、红外光谱以及固体紫外-可见光谱等对两个配合物进行了表征。结构分析证实配合物1和2是通过二维结构堆积成的三维超分子化合物。粉末衍射测试则显示两个配合物在水中有很好的稳定性。固体紫外-可见光谱显示两个配合物属半导体材料,对紫外-可见光有很强的吸收作用。在光催化实验中,配合物1和2可加快亚甲基蓝的降解速度。     

基于2,5-二溴对苯二甲酸配体的锌/钴配合物合成、晶体结构及性质

将有机物2,5-二溴对苯二甲酸(H₂L₁)和2,2′-联吡啶(L₂)作为双配体,使用溶剂热法和七水合硫酸锌(ZnSO₄·7H₂O)、六水合硝酸钴(Co(NO₃)₂·6H₂O)分别反应,得到配合物[Zn(L₁)(L₂)(H₂O)]_n(1)和配合物[Co(L₁)(L₂)(H₂O)]_n(2)。采用单晶X射线衍射、元素分析、红外光谱、紫外光谱、荧光光谱、热重分析等测试方法对这两种物质进行分析研究。单晶测试结果表明配合物1是单斜晶系,以Zn²⁺配位连接L^2-₁与L₂形成一维链状结构,各条链在分子间氢键和π…π共轭作用下有规律地堆叠形成三维网络结构。配合物2是三斜晶系,Co1离子和Co1ⁱ离子由H₂L₁上的羧酸氧原子O4和O4ⁱ连接,形成双齿螯合的配位结构单元,以Co²⁺配位连接 L^2-₁和L₂形成二维网格结构,各层在O—H…O分子间氢键和范德瓦耳斯力作用下有规律的堆叠形成三维网络结构。配合物1和2均含有芳香杂环、羧基杂环和氮杂环,具有良好的荧光性质和热稳定性,最大发射波长分别为345 nm和333 nm。     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Syntheses,crystal structures and properties of Cd(II) and Ag(I) complexes based on 2-p-methylphenyl-5-(2-pyridyl)-1,3,4-thiadiazole

Abstract

Complexes of [CdL₂(NO₃)₂]·1.5H₂O and [Ag₂(μ-L)₂(NO₃)₂] were synthesized by the reactions of 2-p-methylphenyl-5-(2-pyridyl)-1,3,4-thiadiazole (L) with Cd(NO₃)₂·4H₂O and AgNO₃, respectively. Their structures were determined by single crystal X-ray diffraction. The photophysical property and thermal stability were characterized by FT???IR, UV???Vis absorption, fluorescence, and thermogravimetric analysis (TGA). Both complexes belong to the triclinic system with space group p???1. The central metal of [CdL₂(NO₃)₂]·1.5H₂O has a distorted octahedral geometry [CdN₄O₂], while two central Ag(I) atoms of [Ag₂(μ-L)₂(NO₃)₂] exhibit distorted tetrahedral geometries [AgN₃O].     

New organoruthenium metallates containing ferrocenecarboxalidine thiosemicarbazones and their nucleic acid/albumin binding and in vitro cytotoxicity

A string of four new hetero binuclear Ru(III) complexes of ferrocenecarboxaldehyde-4(N)-substituted thiosemicarbazones were synthesized and characterized by various spectral (infrared, ultraviolet–visible, Electron Paramagnetic Resonance (EPR) and High Resolution Mass Spectrometry (HR-MS) techniques. The binding abilities of the ligands/complexes with nucleic acid (calf thymus DNA, CT-DNA) and bovine serum albumin (BSA) were analyzed by absorption and emission titration methods. The complexes exhibited better DNA binding affinity than their parent ligands. The interaction with CT-DNA was found to be intercalative and with BSA static quenching mechanism was observed. All the synthesized Ru(III) complexes were subjected to study their in vitro cytotoxicity against MCF-7 (human breast cancer) and HT-29 (human colon cancer) cell lines. Among the four complexes, complex 3 [RuCp (FF-etsc)PPh₃]Cl exhibited the highest cytotoxicity in MCF-7 cells and complex 4 [RuCp (FF-ptsc)PPh₃]Cl was the most active on HT-29 cells.     

Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

Double Michael Additions of Lithium Enolate of 1,4-Dioxaspiro[4.5]dec-6-en-8-One to Acrylates

Double Michael additions of lithium enolaie of 1,4-dioxaspiro[4.5]dec-6-en-8-one to four acrylates afforded bicyclo[2.2.2]octan-2-ones with high regio- and stereoselectivities in moderate yields.     

2-(2-喹啉偶氮)-5-二甲氨基苯胺光度法测定铜

在pH=4.0的磷酸盐缓冲介质中,CTMAB存在下,2-(2-喹啉偶氮)-5-二甲氨基苯胺(QADMAA)与铜反应生成2:1稳定络合物,络合物λmax=580nm,ε=1.14×105L·mol-1·cm-1.铜含量在0.01-0.6μg/mL内符合比耳定律,方法用于环境样品中铜的测定,结果令人满意.     

Conjugate addition of pyrroles to α,β-unsaturated ketones using copper bromide as a catalyst

Copper bromide was used as a catalyst for the addition of pyrroles to enones. When both the reactants were used in equimolar amounts, mono and dialkylated products were obtained. However, the use of excess enone furnished only dialkylated products. Thus, copper bromide was shown to be an efficient catalyst for the dialkylation of pyrroles.     

Structure and electrochemical behaviour of 4,7-diazaheptyl-trimethoxy-silane and vinyl-trialkoxy-silane adsorbed at silver surface

Novel self-assembled monolayers were obtained on silver using 4,7-diazaheptyl-trimethoxy-silane (SiN) and vinyl-trialkoxy-silane (SiVA, where the alkyl group is 3,6,9,12,15,18,21,24,27,30,33,36,39,42,45,48,51,54,57,60-eicozaoxa- hexaheptaconan). It was shown that thus modified metal surface was protected against electrooxidation. A densely packed monolayer remained stable and did not desorb from the Ag electrode on the potential cycling. The structure of SiN and SiVA as well as their complexes with Li⁺ cations were calculated and visualised by the AM1d and PM5 semi-empirical methods.